The band does not fit and i am curious to see who has done this with their ring?

Keep in mind when you try on a (single) ring it goes to the end of your finger. The width of your finger changes as it nears your knuckle. I'd take it to a jeweler and ask their opinion. So, what's happened here is your fingers are different sizes at different points in your finger and like a corset (for lack of better word) right now those rings just keep pushing everything up and making it wider and harder to fit anything properly.

View Quoted Comment

Thank you, Margaret! I appreciate it! That's a good analogy for comparing it to a corset! I knew I would have to go to the jeweler. But at least two of them fit well together LOL! Do you think I should have them put all three rings together in one piece?

So my ring is an engagement ring with an enhancer, and the guy warned us to only size everything down a half size when my engagement ring by itself was probably a whole ring size off. Now everything fits just fine! I'd just keep that in mind when you're adjusting your rings.

View Quoted Comment

Thank you, Kathryn! I appreciate it! Do you have a picture of it by chance?? So you are saying to make sure it doesn't go bigger or smaller than one size that it is currently correct??

View Quoted Comment Yeah, you want to make sure when you're resizing you don't go too small! Becsuse it'll be tighter with more ring coverage basically. If it's too small, try sizing the top one up a half size. Also mine is soldered together because I knew I would always want to wear both at the same time.

View Quoted Comment

That's completely up to you. I know right now you're completely in love with your set. But think down the road, if you weld them together you will forever have to wear it together. Will it become too bulky down the road?

View Quoted Comment

OMG that's so pretty!! Looks amazing!! Okay, that makes sense!! I'll keep that in mind when I am there! Thank you!!

View Quoted Comment

Thank you, Margaret! That is true, I didn't even think about that! It actually might be too bulky later. I will keep that in mind!

Another thing to consider is.... let’s be honest, most of us are skinnier when single and some doing everything to lose weight for the wedding, then just a few years later bammmm the ring is too small! My ring is 1/2 size too big, I have big knuckles, plus it has a rather big rock on top of it, so it keeps spinning. I bought a ring adjuster as pictured. I think it’s worth to try to separate your rings invisibly since it is cheap anyway. If it doesn’t work out it won’t be a huge loss.

View Quoted Comment

Belle thank you!! You make a VERY good point LOL I was A LOT skinnier when I was single now I have a little love to give you know? LOL So that is a good point and I will keep that in mind when I go to the jewlers. Oh, I did not know they made those!! That's awesome!! They keep them together or from falling off your finger??

View Quoted Comment The adjusters is there to make the ring tighter. It is silicone and it is easy to cut as short or long as you need. It’s also cheap, so I don’t mind to change it when it gets discolored after a while. I change mine every month or so.

View Quoted Comment

Thank you so much, Belle!! I really appreciate the advice!! I didn't even know that they made something like that!! Ill look into those!!